Operation Manual

Maintenance > 59

4. Pull the locking levers at each side of the transfer belt up and towards the front of

the machine.

5. Using the locking levers (a), lift the belt (b) upwards and withdraw from the

machin

6. Lower the new belt unit into place, with the drive gear towards the rear of the

er. Locate the drive gear into the gear inside the printer by the rear right corner

of the unit, and lower the belt unit flat inside the printer.

7. Push the locking levers towards the rear of the machine. This will secure the belt

unit in plac

8. Holding the image drum assembly by its handles, lower it into place in the machine,

loc

ating the pegs at the sides into their slots in the sides of the printer cavity.

9. Finally, close output tray and press down firmly at both sides so that the cover

lat

ches closed.