User's Manual

Manual
1
2
3
4
5
6
7
8
10
11
9
12
9
Buckle clip
3
4
1
2
POWER / MUTE switch
(MUTE indicator)
Channel / Volume switch
LCD screen
Microphone
10
External mic. Input
5
Charging indicator
12
11
Charging terminal
Aux input
6
7
8
Neck strap hole
DC charging input
Strap hole
Others
To reset mode, press / at the same time and switch the
power on.
03/13
11/13
Specifications are subject to change without prior notice.
※
Charging mode
1. LED lits red when charging.
2. LED lits green when battery is fully charged.
3. When device is inserted to charging slot, the device
powers off.
4. Battery error: LED status flashes in red when charging.
(1)The battery temperature is exceeded 60 C.
o
(2)The duration of charging time for charger stand
exceeded 7 hours.
(3)The battery is defected.
Volume switch
LCD screen displays current volume level when
press or (VOL. 1 ～ 3).
Mute / Talk select
Press Mute button for 2 seconds; enter into the Mute
/ Talk switch mode.
Power OFF
Press 2 seconds to turn the device off.
Set up/ Installation
1. Press 0.5 second to turn on.
LCD backlit lits up.
2. When power is on, the button lits blue.
Power ON Channel Synchronization
(Front view) (Side view) (Rear view)
(Top view)
(Bottom view)
1.When the receiver channel has been changed, press “set”
and “mute” buttons at the same time to sync the channel
again.
2.When transmitter is set as Master, the preset channel will
be A. If channel A is occupied, the channel will switch to B
automatically. Once channel A transmitter has been shut
off, channel B will switch back to channel A.
3.When transmitter is set as slave:
a.If channel A is not switched on, channel B will not be
able to transmit, and transmitter shuts off automatically
after 30 minutes.
b.When channel A transmitter is powered off, channel B
transmitter will be powered off as well.
4.Sync range is 15 meters.
1
2
3
4
5
Digital Pendant Microphone EJ-6T
Notice :
The changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the device is permitted. Any
change to the antenna or the device could result in the device exceeding the
RF exposure requirements and void user’s authority to operate the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.