Operation Manual

5
1.0 General
Carefully read the following important information regarding installation, safety and maintenance.
Keep this information booklet accessible for further consultations.
The appliance has been designed as a exhausting version (external exhaust ) or as a filter version
(internal air recycle) cooker hood.
2.0 Installation instructions
Option one:
2.1 The cook
er hoods
shall be placed at a distance of 65-75cm from the cooking surface.
See Pic 1
2.2 To install onto the
wall drill 2 holes of Ø8mm on a suitable place according with the centre
distance of hole in the back of the cooker hood.
2.3 Insert the nut into the holes.
2.4 Insert the screws into the nuts and tighten. Put the cooker hood onto the tightened screws.
See Pic 2
2.5 Fix the cooker hood with safety screw, see Pic 4. The two safety vents are positioned on the
back casing, with diameter of 6mm.
2.6 Put the one way valve onto the cooker hood.
Option two:
2.1 Drill 4 holes of 6mm diameter at the bottom of the hanging cu
pboard
2.2 Put the one way valve on the cooker hood, then install the cooker hood on the bottom of the
cupboard, tighten the hood with enclosed 4 screws.
2.
3 Install the adjusted board on the bottom of the hood in order to keep out the gap between
hood
back and cupboard.