Order Number : GETEC-C1-12-377 FCC Part 15 subpart C Test Report Number : GETEC-E3-12-138 Page 1 / 1 APPENDIX H : USER’S MANUAL EUT Type: Base Station FCC ID.
TRF-GE1 G Extender Owner’s Manual
TRF-GE1 G EXTENDER Congratulations on your choice! TRF-GE1 G Extender Owner's Manual © 2012 Universal Remote Control, Inc. The information in this manual is copyright protected. No part of this manual may be copied or reproduced in any form without prior written consent from Universal Remote Control, Inc. UNIVERSAL REMOTE CONTROL, INC. SHALL NOT BE LIABLE FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORS/OMISSIONS MADE IN THIS MANUAL.
TRF-GE1 G EXTENDER Congratulations! 1 Features and Benefits 1 Parts Guide 1 TRF-GE1 Panel Descriptions 2 Pairing a TRF-GE1 and a TRG-100/200 4 Specifications 5 USA Limited Warranty Statement 6 Federal Communication Commission Interference Statement 8 Declaration of Conformity 9
TRF-GE1 G EXTENDER Congratulations! Thank you for purchasing the Total Control TRF-GE1 G Extender for the MRX-20 Advanced Network System Controller. The TRF-GE1 G Extender is used to extend the normal operational range (30-50 feet) between the TRG-100/200 Umotion remote and the MRX-20 Advanced Network System Controller.
TRF-GE1 G EXTENDER TRF-GE1 Panel Descriptions The front, rear and bottom panel consists of: DC 12V LAN POWER STATUS DATA LED LED LED Reset Pairing Power LED: When illuminated this light indicates the TRF-GE1 is ON. Status LED: The Status LED signifies when the TRF-GE1 is connected to the network: l l Connected: Illuminates green. Not Connected: Remains OFF. Data LED: The Data LED flashes as the TRF-GE1 receives and transmits data.
TRF-GE1 G EXTENDER Pairing: Place the TRF-GE1 G in pairing mode by pressing and holding the Pairing button for three seconds. For pairing a TRG100/200 with a TRF-GE1 G, refer to the section: Pairing a TRF-GE1 G with a TRG-100/200. l Entering pairing mode: Successfully entering the pairing mode is confirmed by the following LED responses: Power LED: Turns ON. Status LED: Flashes orange ON and OFF. Data LED: Remains OFF.
TRF-GE1 G EXTENDER Pairing a TRF-GE1 and a TRG-100/200 Before you can begin to use the TRF-GE1 G Extender with the TRG-100/200 Umotion remote, it is necessary to pair them. The TRF-GE1 G has a Pairing button on the bottom of the unit, this makes pairing possible without the use of a PC. Entering Pairing mode: 1. Use a stylus or paper clip to press and hold the Pairing button (on the bottom of the TRF-GE1 G) for three seconds. 2.
TRF-GE1 G EXTENDER Specifications Microprocessor: ARM32-bit Cortex- M3(120MHz) Power Supply: 12V DC 1A RAM: 128Mbyte Mobile DDR RF Range(radio frequency): 50 to 100 feet, depending upon the environment RF Freqency: 2.425~2.475 GHz NAND: 128Mbyte FLASH: 768Kbytes SRAM: 128 + 4 Kbyte Weight: 3.058 oz Size: 3.74” X 2.7” X 1.
TRF-GE1 G EXTENDER USA Limited Warranty Statement Your Universal Remote Control, when delivered to you in new condition, is warranted against defects in materials or workmanship as follows: UNIVERSAL REMOTE CONTROL, INC. warrants this product against defects in material or workmanship for a period of one (1) year and as set forth below.
TRF-GE1 G EXTENDER LIMITATION OF REMEDIES UNIVERSALREMOTE CONTROLSHALLNOT BE LIABLE FOR ANY INCIDENTALOR CONSEQUENTIALDAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY OR CONDITION ON THIS PRODUCT.
TRF-GE1 G EXTENDER Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation.
TRF-GE1 G EXTENDER Declaration of Conformity Company Name : OH SUNG ELECTRONICS CO., LTD.
NOTE Page 10
NOTE Page 11
NOTE Page 12
NOTE Page 13
NOTE Page 14
NOTE Page 15
500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www.universalremote.
