Owner Manual

Customer Service 1•800•787•6649 19
MODE CHANGE
To change the mode on the spa, first press MODE
to enter mode programming. Press COOL to cycle
through to desired mode (LCD flashes until
confirmed), then press MODE again to confirm
selection.
Standard-In-Economy mode
Pressing JETS 1 while in Economy mode puts the spa
in Standard-In-Economy mode, (“SE”) which
operates the same as Standard Mode, then reverts
to Economy Mode automatically after 1 hour. Dur-
ing this time, pressing “Cool” or “Warm” followed
by “Light” will revert the mode to Economy immedi-
ately.
Standby Mode
Pressing WARM or COOL followed by BLOWER or
JETS 2 will turn off all spa functions temporarily. This
is helpful when changing a filter. Pressing any button
exits Standby mode. On some systems the “Jets 1”
button will control the pump in Standby Mode
(“Drain Mode”). In this case, press any other button
to exit. System will revert to pre-vious mode after 1
hour.
Operational and
Energy Tips
1.Control Valves – air and water
controls on the top of spa
a. Average to Cold Climate - When not in the
spa, make sure the valves are turned off. All these
valves will inject a certain amount of air into the
water which causes a cooling effect. Therefore
your spa will have to heat more often and cost
more money to operate.
b. Hot Climate – Hot tubs are only designed to
heat up and maintain temperature, therefore a
hot climate can actually make a spa over heat. In
these areas, the control valves can be left open all
the time to help cool the spa down.
Operate Your Spa
2.Filter Settings – Time and
Duration
- To set your filter time, simply power your spa on
at desired filter start time. If you power the spa up
at 8:00am, it will filter at 8:00am and 8:00pm daily
until the power is turned off and on again.
- If your electric provider offers different rate per
KWH (peak/off-peak) then you will want your filter
time to take place during off-peak time.
- If you are experiencing over heating with your spa,
have the spa filter run during cooler times of the
day, and leave the control valves opened like
mentioned prior.
- The factory setting is F2, which means the spa will
filter 2 hours for every 12 hour period. 4 hours
total per day. Since we use a large primary pump
for your filtration, it moves a lot of water quickly.
Therefore we recommend you keep your filtration
at no more than F4, anything longer will just waste
electricity and in warm climates the spa may
overheat.
3.Heating Modes – Standard,
Economy, and Sleep
- 4 Button Controllers Only - These options
are not always unlocked from the factory, and
may require a settings change. Attempt to change
the mode several times prior and if no results a
dip switch will need changed.
Standard is the default setting, and you are in
standard mode if none of the other setting codes
show up
- Temperature will be at or near desired tem-
perature constantly.
- Pumps turn on at regular intervals to check and
maintain temperature.
- Best to use at startup of spa, it will heat until
desired temperature is reached.
- Best to use in cold climates.
- Most costly to operate.