Owner Manual

Customer Service 1•800•787•6649 17
One-Pump Spas
Jets
Touch the “Jets” button once to turn the main
2-speed pump on or off, and to shift between low
and high speeds. If left running, the low speed of the
pump will automatically turn off after 2 hours, and
the high speed will automatically turn off after 15
minutes.
Warm/Cool
To display the Set Temperature, press either the
“WARM” or “COOL” button once. The LCD will
begin to flash the set temperature. If you want to
increase or decrease the desired temperature, press
the “WARM” or “COOL” button accordingly. Once
at the desired temperature, allow a few seconds for
the flashing to cease. Your Set Temperature has now
been successfully set.
MODE CHANGE
To change the mode on the spa, press WARM
followed by LIGHT.
One-Pump + Blower Spas or
Two-pump (2-speed + 1-speed)
Jets/Jets 1
Touch the “Jets or Jets 1” button to turn the main 2-
speed pump on or off, and to shift between low and
high speeds. If left running, the low speed of the
pump will automatically turn off after 2 hours, and
the high speed will automatically turn off after 15
minutes.
Boost/Jets 2
The “Boost or Jets 2” button will operate the
blower pump, if equipped, or the 1-speed pump.
MODE CHANGE
To change the mode on the spa, press TEMP
followed by LIGHT.
Operate Your Spa
Jet
V
Press the “Jets 1” button to turn the main 2-speed
pump on or off, and to shift between low and high
speeds. If left running, the low speed of the pump
will automatically turn off after 2 hours, and the high
speed will automatically turn off after 15 minutes.
-HW-HW
Press the “Jet 2/Jet 3” button:
1. Once to turn Pump 2 On / Pump 3 Off
2. Again to turn Pump 2 On / Pump 3 On
3. Again to turn Pump 3 On / Pump 2 Off
4. Again to turn Pumps 2 & 3 Off
Two-Pump + Blower Spas or
Three-pump Spas (4 button topside)
MODE CHANGE
To change the mode on the spa, press TEMP
followed by LIGHT.
“Temp” Button
To display the Set Temperature, press the “TEMP”
button once. The LCD will begin to flash the set
temperature. To change the set temperature press
the “TEMP” button again prior to the flashing timing
out. The temperature will go either up or down. To
change the temperature in the opposite direction
wait for the LCD to stop flashing. Press the “TEMP”
button again to resume the LCD flashing screen, and
then press the “TEMP” button. Once at the desired
temperature, allow a few seconds for the flashing to
cease. Your Set Temperature has now been set.