INSTALLATION AND CARE GUIDE FREESTANDING BATHTUB AN READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION. 2 PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE INSTALLATION OF THIS PRODUCT This products must be installed by a fully insured and licensed plumber only.
TOOLS REQUIRED FOR INSTALLATION (NOT INCLUDED} yy, SF Sat Cloth Stallion Tampa Panel Markab OTHER TOOLS MAY BE REQUIRED or Blanket bursars Harassment N x Adjustable Channel lately Bass Haifa {gel Co die Bun Wench Lack Pliers inspect the bathtub for any damages. F any damage is found pleases contact your retailer Carefully, remove the tub from it's crate/box. Important Note: Bathtub must be carried by a minimum of 2 adult people in upside down position only. Do not carry the bathtub by its panel.
INSTALLATION WITH UNDERFLOOR ACCESS Clean, level and prepare the floor for installation, Place the tub in the exact installed local on on the floor and trace the outline of the bathtub with pencil and mark the drain hole location on the floor. Move the tub away so that the plumbing can be installed. Moving blanket Turn bathtub upside down and set it an a non-abrasive mat, blanket, or cardboard to prevent any scratches on tub rim. Website: Hitp/Awew heatproof.
Place & level across the boom of the tub and adjust the tub feet leveler to touch the level. Then raise the leveler additional 1/8" or 3/16" so that the weight of the tub, water and user are fully supported by the feet adjuster and not the tub walls.pop up cover drain body rubber drain gasket tail piece (provided by installer) floor drain pipe (provided by installer) trap {provided by installer) rubber drain gasket P-trap.
Apply a generous bead of adhesive or waterproof silicone to the bottom of the tub and a bead of tub and tile caulk around the edge of the tub Flip the tub over and carefully set the tub into position with tail piece assembly to P-trap and connect to the drain. Fill the tub with water to the overflow and then drain the tub while inspecting the waste and overflow connection below the floor for any leaks. Access from below will be necessary for this step. Website: Hitp/Awew heatproof.
With the tub now set in place, wipe off any excess tub or tile caulking, adhesive where the tub meets the floor with wet cloth. DO NOT SHOWER or MOVE the tub after installation because it will take about 24 hours to get the silicone sealant to dry. Note: if installing on a concrete slab where no underfloor access or cannot move drain. You may consider following option. Optional flexible drain hes from plumbing hardware or home improvement store may be used GET PRO will not supply this flexible hose).
INSTALLATION DN 51 a8 FLOOR (NO UNDERFLOOR ACCESS) Clean, level and prepare the floor for installation, Place the tub in the exact installed local on on the floor and trace the outline of the bathtub with pencil and mark the drain heel location on the floor. Move the tub away so that the plumbing can be installed. Moving blanket Turn bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent any scratches on tub rim. Website: Hitp/Awew heatproof.
\ Tub feet leveler Website: Hitp/Awew heatproof. com Floor surface Place a level across the bottom of the tub and adjust the tub feet leveler to touch the level. Then raise the leveler additional 1/8” or 3/16” so that the weight of the tub, water and user are fully supported by the feet adjuster and not the tub walls. Measure the actual distance from drain into drain pipe on floor and the drain pipe should extend approximately T above the finish floor. Use a drain adapter {not provided) if necessary. 5.
Apply putty to fix the rubber slip gasket over the drain vent Apply a generous bead of adhesive or waterproof silicone to the bosom of the tub and caulk around the edge of the tub. Flip the tub over and carefully set the tub into position with tail + piece assembly to waste vent and connect to the drain. Website: Hitp/Awew heatproof.
With the tub now set in place, wipe off any excess tub or tile caulking, adhesive where the tub meets the floor with wet cloth. [0 NOT SHOWER or MOVE the tub after installation because it will take about 24 hours to get the silicone to dry. Website: Hitp/Awew heatproof.
IMMEMORIAL GAYER RULES ATTENTION! ALWAYS FOLLOW THESE PRECAUTIONS WHEN USING A BATHTUB A Warning The bathtub must be installed and used as described in this manual Warning Use caution when entering or exiting the bathtub Warning Do not permit children or persons with infirmities to use the bathtub without supervision of an audit A Warning People using any medications or having adverse medical history must consult a physician price ts use of the bathtub to avoid potential hypothermia and possible drowning A
PROPHET GET YOUR HOME A PRO CHOICE More Wholesale Price Home Furniture Products at www.getprohome.com on any of your next purchase special offers & other discounts information send us email to www.getprohome.
