User Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Models Adapt Series Tables (Crest, Rectangle, Trapezoid, Wave and Ying)
Parts Listing
06.1.2017
STOP
A
Table Top
1 Unit
F
Thumb Bolts
4 Units
G
Casters (optional)
4 Units
C
6x16mm Screws
16 Units
B
Legs
4 Units
1
B
A
E
Connector Plate
1 Units
C
2
3
D
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Place Table Top (A) upside down on a clean, flat surface.
Place Legs (B) upside down onto Table Top (A) as shown.
Step 2: Attach each Leg (B) to Table Top (A). Make sure indicator
hole on the leg base faces the center of the table. Attach
by inserting four 6x16mm Screws (C) through the 4 holes
in the base of each leg (B).
Step 3: Adjust the height of the table by aligning it to the desired
hole on the leg. Secure it using 6x12mm Screw (D).
Optional: Attach optional casters (G) if desired.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC 27540
800-520-7471 (voice)
919-303-6389 (voice)
[e-mail]
D
6x12mm Screws
4 Units
indicator hole
B
C
4
To attach multiple
tables together:
Place tables together in desired
configuration. Use Connector Plate (E)
by aligning two holes on one table
with two holes on the other table.
Secure Connector Plate (E) with
Thumb Bolts (F) as shown in step 4.
F
E