User Manual

A
Table Top
1 Unit
B
Mounting Plate
1 Unit
F
Mounting Plate Bolts
4 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model XT Tables / XTC Tables
Standard and Café Height X-Style Base Tables
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[e-mail]
STOP
Assembly Instructions
Tools Needed: Allen Wrench
Please read all instructions before assembly.
Step 1: Place the center post(D) securely on a flat,clean surface.
Place the mounting plate (B) down on top of the center
post(D). Tighten the screw(E).
Step 2:
Place the finished part upside down to make the mounting
Step 3: Place the table top(A) onto the mounting plate(B),then
Note: If table seems to wobble, adjust the built-in leveling glides
on the base to make the table secure.
C
Table Base
1 Unit
D
Center Post
E
Screws
6 Unit
A
B
F
D
E
C
E
SCREWS
plate(B) on the flat surface end,then place the table base(C)
on the other end. Tighten the screw(E). Put all the finished
part upside down again to make the frame as its normal
placement.
tighten the screw(F).