User Manual

Models OT24RD & OT36RD Orbit Series Tables
2
3
1
D
A
H
1
STOP
Assembly Instructions
Tools Needed: Allen Wrench - Included
Two people are needed for assembly
Step 1: Secure the Table Top Center Support (B) to the top of the Center Post (C)
using the Long Screw (G). Place the 3” Top Support Ring (E) between the
Long Screw (G) and the Table Top Center Support (B) before tightening with
the Large Allen Wrench (J).
Step 2: Flip the Center Post (C) over and place the Base (D) securely onto the end of
the Center Post (C). Attach the Base Connector Plate (F) specific to the model
number to the Base (D) using the Long Screw (G) and tighten with the Large
Allen Wrench (J).
Step 3: Place the Table Top (A) upside down on a clean, flat surface and align the
Table Top Center Support (B), placing it on the underside of the Table Top (A).
Using the Small Allen Wrench (I), secure all six Short Screws (H) into place
on the underside of the Table Top (A). The table is heavy when fully
assembled. Two people will be needed to turn the table right side up.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[e-mail]
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
12.15.2016
G
F
C
C
D
B
J
G
J
E
I
B
C
B
Table Top Center Support
1 Unit
A
Table Top
1 Unit
Parts Listing
D
Base
1 Unit
I
Small Allen Wrench
1 Unit
J
Large Allen Wrench
1 Unit
E
3” Top Support Ring
1 Unit
F
8” Base Connector Plate
1 Unit (OT36RD)
F
3” Base Connector Plate
1 Unit (OT24RD)
C
Center Post
1 Unit
G
Long Screw
2 Units
H
Short Screw
6 Units