User Manual

Screws
4 Units
Allen Wrench
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model E1009
WEIGHT CAPACITY: 250 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[e-mail]
10.08.2012
A
Chair Back
1 Unit
B
Chair Seat
1 Unit
C
Chair Base
1 Unit
D
Casters
5 Units
E
Seat Mechanism
1 Unit
F
Telescopic Bellows
1 Unit
G
Gas Lift
1 Unit
H
I
J
K L
Tilt Tension Knob
1 Unit
Large Washer
1 Unit
Small Washer
1 Unit
1
F
G
C
D
2
E
H
B
I
3
K
J
B
A
4
G
B
STOP
Assembly Instructions
Tools Needed: Allen Wrench (provided)
Please read all instructions before assembly.
Step 1: Insert Casters (D) into bottom of Chair Base (C). Insert Gas Lift (G)
into center hole of Chair Base (C). Cover the Gas Lift (G) with the
Telescopic Bellows (F).
Step 2: Attach the Seat Mechanism (E) to Chair Seat (B) using Screws (H).
Tighten with Allen Wrench (L).
Step 3: Attach Chair Back (A) to Chair Seat (B) by inserting Tilt Tension Knob (I)
through Small Washer (K), then Large Washer (J), and into bottom of
Chair Seat (B) through hole in Seat Mechanism (E).
Step 4: Attach assembled chair to Chair Base (C) by inserting top of
Gas Lift (G) into the hole in the center of the Seat Mechanism (F).
Press down firmly on the Chair Seat (B) to secure.