User Manual

Marque Reception Station
Assembly Instructions, continued
Please read all instructions before beginning.
NO TOOLS REQUIRED TO ASSEMBLE.
Two people are needed for disassembly and reassembly.
Note: It is important to build the Reception Station in the place it will be used as it is difficult
to move after built.
• If you purchased models 55292 or 55312
(
2 sections
)
, 55293 or 55313
(
3 sections
)
,
55294 or 55314
(
4 sections
)
, 55296 or 55316
(
5 sections
)
, follow steps 1A, 6, 7 & 8.
Step 6: Attach Panel Support
(
H
)
to Curved Panel
(
D
)
by placing support next to Curved Panel
(
D
)
and inserting the steel ears on Curved Panel
(
D
)
into holes of Panel Support
(
H
)
and pressing
down on Curved Panel
(
D
)
to lock into place. Attach another Curved Panel
(
D
)
to Panel
Support
(
H
)
and secure in same manner. Repeat this step for as many sections as you have.
When all Curved Panels
(
D
)
are secured, attach the remaining Side Wall
(
C
)
to the last Curved
Panel
(
D
)
by inserting the steel ears on Curved Panel
(
D
)
into holes of vertical support beam
attached to Side Wall
(
C
)
and press down on Curved Panel
(
D
)
to lock it in place.
Step 7: Attach Work Surface Top
(
B
)
by placing it on top of Panel Support
(
H
)
and horizontal support
beam attached to Side Wall (C). Attach Support Bar
(
E
)
from underneath by placing it diagonally
from the front of Side Wall
(
C
)
to the back of Panel Support
(
H
)
and secure with two Long Safety
Knobs
(
G
)
. Insert them through Support Bar
(
E
)
and the horizontal support beams of the
Side Walls
(
C
)
then into the bottom of Work Surface Top
(
B
)
. Use two Short Safety Knobs
(
F
)
to finish attaching Work Surface Top
(
B
)
by inserting them through remaining holes in horizontal
support beams of the Side Walls
(
C
)
and into the bottom of the Work Surface Top
(
B
)
and tighten.
Repeat this step for as many sections as you have with the last Support Bar
(
E
)
and Work
Surface Top
(
B
)
attaching to Side Wall
(
C
)
.
Step 8: Place Transaction Top
(
A
)
on support brackets attached to top of Side Wall
(
C
)
and Panel
Supports
(
H
)
. Place 1 Connector Plate
(
I
)
under the Transaction Shelf
(
A
)
on the outside where
2 sections connect and allign with holes in supports. Secure using Short Safety Knobs
(
F
)
in
four holes. Flip up center support tab on inside of Side Wall
(
C
)
and secure with Short Safety
Knob
(
F
).
Repeat this step for as many sections as you have with the last Transaction Top
(
A
)
attaching to the Side Wall
(
C
)
. You can now tighten all knobs securely.
page 3
6
D
C
H
7
E
F
F
G
G
G
GF
C
H
B
8
A
I
F
A
F
Three Section
Reception Station
Models 55293 & 55313
Five Section
Reception Station
Models 55296 & 55316