User Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Parts Listing
for Multiple Sections
• 919-362-4765 (fax)
• www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[e-mail]
06.29.2016
Assembly Instructions
Please read all instructions before beginning.
NO TOOLS REQUIRED TO ASSEMBLE
Two people are needed for disassembly and reassembly.
Note: It is important to build the Reception Station in the place it will be used as it is difficult
to move after built.
• I
f you already have an existing Marque Reception Station and are adding sections to it,
follow steps 4 - 8.
• If you purchased models 55292 or 55312
(
2 sections
)
, 55293 or 55313
(
3 sections
)
,
55294 or 55314
(
4 sections
)
, 55296 or 55316
(
5 sections
)
,
follow steps 1A, 6, 7 & 8.
Step 4: Detach Transaction Top
(
A
)
by removing all 5 Short Safety Knobs
(
F
)
and placing them to
the side for later use. Now detach Work Surface Top
(
B
)
by first removing the Support Bar
(
E
)
.
Remove the two Long Safety Knobs
(
G
)
first, then the Short Safety Knobs
(
F
)
and place
them to the side for later use.
Step 5: Remove one Side Wall
(
C
)
by holding it tight and lifting upward on the Curved Panel
(
D
)
. This
will disengage the steel ears from the holes of the vertical beam attached to the Side Wall
(
C
)
.
NOTE: Please see page 3 to continue assembly of Multi-Section Stations.
4
A
E
F
B
G
F
F
F
J
5
D
C
B
Work Surface Top
1 Unit Per Section
A
Transaction Top
1 Unit Per Section
C
Side Wall
2 Units
D
Curved Panel
1 Unit Per Section
E
Support Bar
1 Unit Per Section
F
Short Safety Knob
7 Units Per Section
G
Long Safety Knob
2 Units Per Section
H
Panel Support
1 Unit Per Section
J
Leveling Glide
1 Unit Per Section
I
Connector Plate
1 Unit Per Section
Marque Reception Station
page 2