User Manual

Parts Listing for
Single Section Station
• 919-362-4765 (fax)
• www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[e-mail]
06.29.2016
B
Work Surface Top
1 Unit
A
Transaction Top
1 Unit
C
Side Wall
2 Units
D
Curved Panel
1 Unit
E
Support Bar
1 Unit
F
Short Safety Knob
7 Units
G
Long Safety Knob
2 Units
H
Leveling Glide
1 Unit
2
E
G
G
F
B
F
Assembly Instructions
Please read all instructions before beginning.
NO TOOLS REQUIRED TO ASSEMBLE SINGLE SECTION STATION. Two people are needed for assembly.
• If you purchased models 55290 or 55310 (1 section) follow steps 1-3.
• If you already have an existing Marque Reception Station and are adding sections to it, follow steps 4 - 8.
• If you purchased models 55292 or 55312 (2 sections), 55293 or 55313 (3 sections), 55294 or 55314 (4 sections),
55296 or 55316 (5 sections), follow steps 1A, 6, 7 & 8.
Step 1A: Insert Leveling Glide
(
H
)
into base of Curved Panel
(
D
)
if not already attached. Stand Curved Panel
(
D
)
up with
Leveling Glide on floor. While one person holds Curved Panel
(
D
)
, place one Side Wall
(
C
)
alongside Curved
Panel
(
D
)
as shown. Slide steel ears on the Curved Panel
(
D
)
into holes of vertical support beam attached to
Side Wall
(
C
)
and force downward to lock panel.
Step 1B: Attach other Side Wall
(
C
)
as explained above.
Step 2: Place Work Surface Top
(
B
)
on top of horizontal support beams attached to the Side Walls
(
C
)
. Attach
Support Bar
(
E
)
from underneath by placing it diagonally from the front of one Side Wall
(
C
)
to the back of the
other and secure with two Long Safety Knobs
(
G
)
. Insert them through the Support Bar
(
E
)
and the horizontal
support beams of the Side Walls
(
C
)
then into the bottom of the Work Surface Top
(
B
)
. Use two Short Safety
Knobs
(
F
)
to finish attaching Work Surface Top
(
B
)
by inserting them through remaining holes in the horizontal
support beams of the Side Walls
(
C
)
and into the bottom of Work Surface Top
(
B
)
and tighten.
Step 3: Place Transaction Top
(
A
)
on support brackets attached to the top of each Side Wall
(
C
)
and secure using
Short Safety Knobs
(
F
)
in all holes. Flip up center support tab on inside of Side Wall
(
C
)
and secure with
Short Safety Knob
(
F
).
You can now tighten all knobs securely.
NOTE: Please see page 2 to continue assembly of Multi-Section Stations.
3
F
A
Marque Reception Station
page 1
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
D
H
C
C
1A 1B