Installation Guide

21
Caulk Gun
Measuring Tape
Metal Shears
Roofing Sealant
Safety Equipment
Plastic Underlayment
Flashing
TOOLS & PARTS
Draw a horizontal line across the center of the hole in
the roof, running side to side the entire width of the
Formable Flashing.
1
Cut a slit through the METAL ROOF PANEL ONLY
across the horizontal line. Use gloves for safety.
2
With your safety gloves on, be sure your cut is
smooth and free of sharp edges.
3
2
Slide the Plastic Underlayment Flashing through the
slit under the upper metal panel and felt paper.
Then down under the lower metal panel. Be sure the
opening is aligned with the cut hole.
4
Run a continuous bead of sealant between the
Underlament Flashing and the next layer of roofing
around the opening.
5
4
Cut Slit In Roof Panel
Section-12b
Metal Roofing Installation-
Using Formable Aluminum Flashing
Plastic Underlayment Flashing fully
inserted underneath metal roof
4
5