Instructions / Assembly

21
Caulk Gun
Measuring Tape
Metal Shears
Roofing Sealant
Safety Equipment
Plastic Underlayment
Flashing
TOOLS & PARTS
Draw a horizontal line across the center of the hole in
the roof, running side to side the entire width of the
Formable Flashing.
1
Cut a slit through the METAL ROOF PANEL ONLY
across the horizontal line. Use gloves for safety.
2
With your safety gloves on, be sure your cut is
smooth and free of sharp edges.
3
2
Slide the Plastic Underlayment Flashing through the
slit under the upper metal panel. Then down under
the lower metal panel. Be sure the opening is aligned
with the cut hole.
4
Run a continuous bead of sealant between the
Underlament Flashing and the next layer of roong
around the opening.
5
4
Cut Slit In Roof Panel
Section-12b
Metal Roofing Installation
Plastic Underlayment Flashing fully
inserted underneath metal roof
4
5