Instructions / Assembly

6
Tighten the top screw and insert housing
screws into all remaining pre-drilled holes
on each vertical housing flange (2 total
per side). Tighten all screws.
Release the slider bar and drill 1/4" holes
in the sill and the top molding. Deploy
the slider bar with latch hook to the
middle of the track. Drop slide bolts
into these top and bottom holes.
TIP: For a tailored fit around door
moldings, notch each plastic sill
plate extender using a utility knife.
Interior View
Interior View
Deploy slider bar with latch hook
until it reaches the middle of the
track. Mark the position of the slide
bolts on the sill and top molding.
Deploy slider bar with latch until it
reaches the middle of the track and
latches onto the hook.
Verify the latch and latch hook align
properly. Latch hook can be adjusted
as needed with a hand screwdriver.
TIP: Latch hook can be oriented either
hook up or down to connect with latch.