Installation Guide
7
OceanLED INSTALLATION MANUAL / DOCK / 270717 / v7.1
Chapter 2: Installation
Note: OceanLED makes every eort to protect our marine and fresh water environment as well as our
natural resources. Please take care to keep packaging away from and out of the water by ensuring loose
packaging materials are secured and not susceptible to being blown into the water. Please recycle all
packaging materials as the sustainability of our environment is everyone's responsibility.
WARNINGS:
• Never use power tools to secure your lights; hand tighten only.
• We recommend you use screws provided. If alternative screws are used, do not use counter sunk or non
flat shoulder screws to secure your lights.
• Please check all components prior to installation. If there is any damage to connectors, cables, and/
or any other component, please notify OceanLED BEFORE installation. Failure to notify OceanLED of
damage in transit prior to installation will lead to violation of warranty.
• Do not submerse your cable in water; cable and connections exposed to underwater submersion will
not be covered by warranty. Mounting the light in any other configuration, other than those described
in this guide, will invalidate its warranty.
2.1 Installing Dock Light Model Light Fixtures
Fixed
1. Install ½ inch conduit into dock light, feeding the cable through the conduit. Bond the conduit to the
dock light using PVC solvent weld adhesive (not supplied).
2. Mark the positioning of the 2x mounting holes and drill pilot hole or adequate sized hole for screw
anchor / wall plug.
3. Attach the unit to the installation surface using 2x screws provided.
4. Once the light is installed protect the top of the conduit from water ingress
Floating
1. Install ½ inch conduit into dock light, feeding cable through the conduit. Bond the conduit to the
dock light using PVC solvent weld adhesive (not supplied).
2. Install the other end of the conduit into to Tee adapter feeding cable through the 90⁰ exit and bond
in place using PVC solvent weld adhesive (not supplied)
3. Mark the positioning of the 4x mounting holes on the metal bracket and drill pilot hole or adequate
sized hole for screw anchor / wall plug.
4. Fix the conduit it places using the central detent pin. Ensure the pin is pushed all the way through
both sides of the bracket.
5. The light can now be lowered into the water and locked into place using the bottom detent pin.
2.2 Connecting lights to your power source
WARNINGS:
• Always consult a qualified electrician when connecting OceanLED light fixtures.
• When connecting light units, please note that all OceanLED lights will operate within a specific voltage
range.
2
CHAPTER
TWO