Installation Guide

88
3
CHAPTER
THREE
OceanLED INSTALL / M6-A6 / 280417 / v7.0
Chapter 3: Maintenance, Repair, & Parts
NOTE: M6/A6 lights have active thermal protection. This means that under normal ambient conditions they
run at full power. Moderate dimming may be noticeable if high ambient temperatures are reached to
avoid damage.
3.1 Cleaning Instructions
CAUTION: Harsh cleaning solvents will damage the light and Tritonium coating.
Sea growth can collect quickly on the light and this can reduce the performance in just a few weeks. To
prevent the build-up of sea growth, all OceanLED lights have been coated with a specialized Tritonium
coating which makes the surface of the lens a non-stick layer which helps ward o long term barnacle
buildup. Lights should be cleaned with a boat brush or similar biweekly or as needed to keep the lens of the
light clear. Growth varies greatly around the world and maintenance is imperative to the proper operation
and longevity of the product. This can be done in the water using a plastic scraper. If out of water, moisten
the growth before wiping.
3.2 – Replacement Parts
Lost, broken, and worn parts should be replaced immediately and can be obtained through your dealer or
from the manufacturer.