Installation Guide

4. Insert the complete light unit (mounting tube assembly + light cartridge) into the

hull, pressing the light hard into the hull and twist slightly to spread the sealant

around behind the light to ensure good adhesion.

5. Ensure the light orientation is correct with the red arrow sticker on the rear lid

pointing up perpendicular to the waterline.

This process is made much easier if a second person is inside the hull to receive

the light and install the locking equipment whilst supporting the light from the

outside. Breakages due to lights falling out of the hull are NOT covered under

warranty and can cause serious bodily injury as can any falling object.

6. (If using Delrin sleeve) insert Delrin sleeve washer over mounting tube until ﬂ ush

with the hull.

7. Insert the stainless steel compression washer onto the mounting tube.

The stainless steel compression washer does not need to be ﬂ at to the hull, a

slight uneven surface can be taken up by the washer.

Installation

2019 INSTALL & OPERATION MANUAL

EXPLORE E3