Operation Manual

42
®
ginning with step 4 if you just set the Alarms:
1. Press the Advance/Left button 4 more times to advance to the Set Mode.
2. Press the Select/Right button to select the Set Mode.
3. Press the Advance/Left button 6 times to advance to the LINK setting.
SET:LINK will appear, with LINK flashing (Fig. 46).
4. Press the Select/Right button to select the Link Mode (Fig. 47).
5. Compare the 6 digit serial number code shown on the display to the first
6 digits of the serial number embossed on the Transmitter.
a. If the numbers are the same, press the Select/Right button 6 times to ac-
cept (save) the code number shown. DO NOT press the Advance/Left
button, this will change the code to an incorrect number.
b. If the numbers are not the same, press the Advance/Left button to change
the first digit of the code as required, then press the Select/Right button
to save that digit. Repeat until all 6 digits are set correctly.
If you would like to set the Display Module to function as a stand alone, non
pressure integrated computer, use the control buttons as described above to
set the code as 999999 (Fig. 48).
After the Link code has been set, SET:LANG will appear with LANG flashing.
To set your preferred Language continue with step 4 of the following Set Lan-
guage procedure, or to return to the Surface Mode press the Advance/Left but-
ton once.
®
0
5
10
20
30
40
50
60
Fig. 48 - Stand Alone
®
0
5
10
20
30
40
50
60
Fig. 46 - Set Link
®
0
5
10
20
30
40
50
60
Fig. 47 - Link Mode