Operation Manual

103
DataTrans Plus
To install the Transmitter on your regulator first stage:
• Remove your current pressure gauge high pressure hose, or high pressure
port plug from the regulator first stage port marked “HP” with the
proper wrench or hex key.
• Very lightly lubricate the o-ring and threads of the Transmitter fitting
with a halocarbon based lubricant such as Christo-Lube MCG111 (pro-
vided in the Oceanic battery kit).
• Thread the transmitter clockwise by hand into the regulator HP port and
tighten until secure with a 5/8” open-end wrench.
• Attach the regulator first stage to a full scuba cylinder.
• Open the cylinder valve slowly, listening for gas escaping around the fit-
ting. If gas is leaking, take the complete regulator system to an Autho-
rized Oceanic Dealer for inspection and repair.
TRANSMITTER COMPATIBILITY WITH NITROX
All Oceanic DataTrans Plus Transmitters can be used with com-
pressed air and/or nitrogen-oxygen (Nitrox) breathing gas mixtures
in which the percentage of oxygen (O2) in the Nitrox mixture does
not exceed 50 (%). However, use with Nitrox (up to 50%) requires
that the Transmitter end fitting be Oxygen Cleaned and fitted with
Nitrox compatible parts (i.e., o-ring and lubricant) by an authorized
Oceanic Dealer Nitrox Service Technician.