Owners Manual

10
ACCESSORIES
CEILING PANEL DUCT KIT
A ceiling panel kit is available for discharging the
condenser air above a drop ceiling. The ceiling
panel duct kits are furnished with a white vinyl
coated flexible duct that allows for convenient
installation. A 2ft X 2ft ceiling duct- panel is
included to replace a 2ft X 2ft drop-ceiling panel
where the connection is desired.
The CK-12 is available for PAC12,18, and 24.
The ceiling panel kit consists of 8 feet of flexible
duct, a 2' X 2' lay in ceiling panel and a 12 inch
duct flange that attaches to the condenser air
discharge opening on the top of the unit. The
CK-16 (for 3 and 5-ton units) consists of a
ceiling duct-panel, and a 16 inch flexible duct.
Note—Drop ceiling spaces should be
vented or large enough to handle the warm
condenser air. Check local codes to assure
compliance.
If longer runs of duct are required, table below
lists maximum duct run with no bends. For every
90° elbow, subtract 6 feet from the run.
Ceiling
Kit
Model
Flexible Duct
Diameter X
Length
Fits
PAC12
Fits
PAC18
Fits
PAC24
Fits
PAC36
Fits
PAC60
CK-12
12 inch X 8 feet
  
No No
CK-16
16 Inch X 8 feet
No
No No
 
25
(.20)
50
(.25)
50
(.25)
50
(.25)
100
(.50)
Maximum Equivalent
Feet (approx)
(ESP)
2 x 2 CEILING
DUCT-PANEL
VINYL COATED
FABRIC DUCT
DUCT FLANGE
DUCT STRAP
DUCT FLANGE
The optional duct flange allows for round flexible ducting to be
attached to the PAC condenser discharge. DF-12
(12-inch diameter) fits all units except the 3 ton/5 ton. The
DF-16 (16 inch diameter) fits the 3 ton model PAC36,
and 5 ton Model PAC60.
NOTE: PAC36 and PAC60 units come with
duct flange installed.