Thermostat Operation Manual

FX-Maxx Operations Manual
BASIC OPERATION
POWER BUTTON Press the power button once to toggle the unit to the on mode. Press the power
button again to toggle the unit to the off mode.
[ FAN ]II1II AUTO
SPEED MANUAL
I' ;,1 10J!IWi1I +;,','1 IF' %'1 191' &I IID>':I1
FAN BUTTON Press and release the fan
button to advance from auto to manual fan.
Press and release to increase the manual fan
speeds, 1 through 6. Press and release again
returns to the auto fan mode. The selected fan
mode is indicated by the Auto and Manual fan
LED's
B
INb':lI] AUTO
MODE ""'"Mi. COOL
I':':II'IIIIHEAT
MOISTURE
CONTROL
B
INI'I;]1:" INSIDE
TEMP
1
1§:@]1'1 DISCHARGE
ELECT
E;9JWI SETPOINT
UP BUTTON Momentarilypress and the set
point will appear in the temperature display.
rwl W I
The set point increases one degree each time
~ ~ the up button is pressed and released.
DOWN BUTTON Momentarily press and release to display the set point. The set point is decreased
one degree each time the down button is pressed and released.
MODE BUTTON The mode button is used to select one of 4 Operating Modes. Press and release to
advance to the next mode. Continue to press and release until the desired Operating Mode is reached.
The mode selected is indicated by the Mode LED.
TEMP SELECT BUTTON Press and release to view inside [return] air temperature, outside
[discharge] air temperature or set point. The appropriate LED will be lit indicating the temperature is dis-
played.
THREE DIGIT DISPLAY The inside [return] temperature is displayed whenever the control is turned
on. The display provides a readout of the inside air temperature which is located in the supply duct.
HEA T MODE LED The heat mode LED is lit when Heating is selected.
COOL MODE LED The cool mode LED is lit when the Cooling is selected.
AUTO LED The auto LED is lit when the "Automatic Heating or Cooling Mode is selected. The control
will automatically switch to heating or cooling when this mode is selected.
MOISTURE CONTROL LED The moisture LED is lit when the Moisture Control is selected.
MANUAL FAN LED The manual fan LED is lit when a manual fan speeds is selected.
AUTO FAN LED The auto fan LED is lit when automatic fan speed operation is selected.
FAN SPEED BAR GRAPH There are six [6] individual fan speed LED's. Each LED represents one
[1] fan speed. Low fan [1] is indicated by illuminating the first LED. High fan speed is indicated by illu-
minating all six [6] LED's.
COMPRESSOR LED The system operating status [Compressor On or Off] is indicated by turning
On the right most decimal point in the 3 Digit Display.
Revision: 03 01/02/98
Page 1