User's Manual

Ocean Signal SafeSea S100 User Manual
Part Number Version 0.0a 7
lost overboard.
Remove the cap from the top of the pole and then pull out the
sections until fully extended. Make sure the sections are tight by
pulling on them.
Fit the smallest section into the hole in
the bottom of the SART as shown, again
making sure it is pushed in tightly.
Raise the SART up vertically and attach
the pole to the liferaft. Most liferafts will
be fitted with suitable attachments to
accommodate the SART pole.
Alternatively, the SART may be attached
directly to the liferaft canopy.
Activation
The S100 SART should only be activated if there is grave and
imminent danger to the vessel and its crew.
To activate the SART, remove the unit from its mounting bracket.
Break off the clear protective cover over the green and red controls.
Push the Red button down, while holding the Green interlock button
to the left.
Release the Green button first to lock the Red button in the active
position.
During operation, the Red LED next to the Test button will flash
once every 2-3 seconds to indication the SART is operational.
When activated by a received radar pulse the Red LED will start
flashing rapidly as indicated diagrammatically below.
Operational:
Activated:
Deactivation
If the SART has been inadvertently activated, it can be turned of by
reversing the activation process.