User's Manual

Table Of Contents

4. After the above settings are completed, press the left ! button to exit

and make sure the Alarm is turned on. You will see the Alarm icon

appeared on the display if it is activated.

Sleep Timer Setting

You can set the timer to let the radio go standby after certain time elapsed

in the range of 15 minutes to 180 minutes.

You can press <Sleep> button on the remote controller to set the timer.

You will see the icon appeared on the display if the timer is set.

Configuration

Network

There are two options under this setting: Wi-Fi Network and Wi-Fi

Channels

Wi-Fi Network

¢ Add / Remove AP

Add AP – It will scan out a list of routers available nearby

Remove AP – If you have already added a router and want to remove

it, choose this option.

¢ AP: [ ]

If you have added more than one routers on the radio and want to

switch to another one, select this option to change.

¢ Signal

This is to show the strength of the Wi-Fi Signal of the Wi-Fi router as

received by the radio. Usually signal levels lower than -70dBm is at

weaker level and if it affects the reception of your radio, you may need

to optimize the router location or check any problem of the router

itself.

¢ IP

The IP is set <Dynamic> by default. Select to change <Fixed> IP

according to your network condition.

¢ DNS

The DNS is set <Dynamic> by default. Select to change <Fixed> DNS

according to your network condition.

Wi-Fi Channels

Not all of the Wi-Fi channels are available in every country. There may

be variation between different countries. Therefore it is necessary to

choose the Wi-Fi channels to ensure the Wi-Fi performs satisfactory.

Alarm Sleep Timer

1. fm Bay Smooth Jazz

H2 ch

< 18/11225 00:25

iRadio