Use and Care Manual

SPECIAL CARE & SAFETY INSTRUCTIONS

WATER: Do not operate the OceanBlue for too long without changing the water. When

you notice that the water is getting too full of dust and fuzz, throw it away and replace it

with clean water. The correct level of water is that of the height of the central post of

the water container.

WATER CONTAINER: When you ﬁnish cleaning your house, be

careful to put away the OceanBlue‘s motor apart from the water

container between uses. ALWAYS empty the water container after

each use.

THE HYDROTURBINE IS THE HEART OF YOUR MACHINE Unplug the

OceanBlue from the power outlet. Remove and clean the

HydroTurbine after each use. Wash it inside and out with water and

soap, using the brush provided. Dry it and put in place again. Tighten

the nut by hand until the ﬂ at surface of the HydroTurbine is

properly adjusted. Do not over tighten, as the HydroTurbine

automatically tightens upon starting the machine. The HydroTurbine

is the key for separating the dirty water from the airﬂow and proper

care is important for the performance of your appliance. If the

HydroTurbine should become damaged (CHIPPED OR BROKEN), replace the

HydroTurbine with a factory made turbine from your Service Center. WARNING: The

OceanBlue must NEVER be used without the HydroTurbine. Always place it back after

cleaning it.

SERVICING OF DOUBLE INSULATED APPLIANCES: For your safety and protection, your

OceanBlue is a DOUBLE INSULATED appliance. NEVER attempt service on the electrical

parts of the appliance EXCEPT at your OceanBlue Service Center. There are special

requirements for servicing DOUBLE INSULATED appliances. Failure to do so can cause

safety hazards with your unit.