Use and Care Manual

WATER CONTAINER / HYDROTURBINE

To empty the water container:

1. Release both clamps by pulling the

upper part of the clamp assembly down

and remove motor.

2. Pickup the water container by the

vacuum intake end and empty the water.

3. Place the heavier particles in the

bottom of the water container in a trash

can (such as wet fuzz)

4. Wash, rinse and dry the water

container

5. Keep the motor apart from the

water container until next use.

Care of HydroTurbine:

Take out the turbine after each use and

wash it inside and out with water and

soap, using the special supplied tool. Dry

it and put it back in its place. Tighten the

nut by hand until the turbine is seated

and the rim is flush with the rim of the

metal casting of the motor. Do not over

tighten, as the HydroTurbine

automatically tightens up on starting the

machine.

WARNING: The HydroTurbine must always be positioned back in its place immediately after

you clean it. Do not operate the machine without the HydroTurbine.