Instructions / Assembly

STEP 6

STEP 7

• Stand step upright and locate two short handrail posts (B).

• The short handrail posts should be installed into the holes

located on the second step with closed end inside the hole

and the open end facing up.

• Screw handrail posts into place using (2) screws from

hardware bag (J).

• Once step is placed in pool, tip the step

forward and move it left and right to

ensure that air escapes and water enters

the steps and risers. This will help keep

the step stationary in the pool.

• In order for step to sit properly

, it must be

weighted in place using approximately

40 lbs of sand. To weight step, place

funnel in opening of side panel on top

step that is now inside pool. Pour 20 lbs

of sand into EACH side of the step.

NOTE

When installing a step inside of your pool it is recommended to

install a step mat underneath to protect your liner. This item is sold

separately.

NOTE

You may need to rock the step back and forth a little to distribute

the sand so the 20 lbs will fit in each side of the step.

Place funnel up

here and pour

sand through

these posts

NOTE

Do NOT install long handrail posts at this time,

they must be installed after completing Step 7.

• Place assembled step INSIDE the pool where you would like to enter the pool. Filter

should be switched off to stop water circulation.

a. If you have a deck, position step in area where it can be attached to your deck.

If you

have the Step without ladder or Pool Step Entry System position

step where you would like to enter the pool.