Instructions / Assembly

STEP 4

• Leave the side panel facing upward and position one

of the lock caps (I) centered over any hole on the

side panel.

• Using a small rubber mallet or a (block of wood and

a small hammer), tap on the locking cap until it is

secured over the pin sticking through the side of the

step and is flush with the side panel.

• Repeat this procedure for each of the additional

seven openings on this side of the step.

• Flip step so that other side panel is facing upwards

and repeat above for the eight holes on this side.

STEP 5

• Leave the side panel facing upward and posi-

tion one of the bases (E) under the side panel

with the channel against the step.

• Secure the base to the side panel with

two zip ties. There is a molded groove in

the base for placement of the zip tie.

Tighten zip tie securely.

• Repeat for opposite side.

NOTE

Zip tie should catch and lock when pulled tight, if it does not then

turn the zip tie over and reattach.

NOTE

To prevent damage to liner, make sure that the locking tab on zip

tie is positioned so that it will NOT come in contact with liner.