Instructions / Assembly

STEP 1

• Lay one of the side panels (H) down on a flat surface.

• Each step (C) has a groove where the riser will slide in

which is located on the bottom of each step.

• Line up a step (C) by positioning the connected dowels

on the step with two of the round holes on the side

panel (H). NOTE: Make sure that the treads on the step

are facing towards the T

OP of the side panel (the skin-

nier part of panel) and that the riser groove on the step

is towards the back of the step.

• Push the step until it clicks in place. Repeat for each of

the three remaining steps (C). If necessary, you may use

the rubber mallet or hammer with wood on top to tap

into place.

STEP 2

• Insert a riser (D) between each of the steps. Locate

the hole in the center of the riser. This hole should

face towards the back of the side panel.

• The riser should slide right into the grooves on the

steps and the square notches should fit right into

the recessed openings on the panel.

• Repeat for each of the three remaining risers.

STEP 3

• Once all risers are in place, line up second side

panel with the connected dowels on installed steps.

• Push down on side panel to lock in place, if neces-

sary use rubber mallet or (hammer with piece of

wood) to fully seat side panel.

TOP OF PANEL