Installation Guide

Oceanair Marine Ltd Chichester PO20 0AY England
Tel: [phone] Fax [phone] www.oceanair.co.uk Email: [e-mail]
© Oceanair Marine Ltd, May 2008
Change 573, Issue 1, May 2008
Mounting Instructions
• The brackets are designed to fit in behind
the internal portlight flange using the port-
light fixings for location. Take care to
ensure that the sealing of the portlight is
not compromised.
• When fitting the peg ensure that the
thickness of the boat structure is deep
enough to prevent the fixing screw breaking
through. Limit the drilling depth by putting masking
tap on the drill bit. The peg should be fitted approximately
230mm (91/16") down from the top fixing screws.
• The deployed blind can be held in position using the
loop. This can be looped over either a peg fitted below the
portlight or a suitable feature on the hatch.
• The blind is held in the stowed position using the two vel-
cro straps on the head rail.
Care & Maintenance
• Fabric may be cleaned with a foam upholstery cleaner.
For light cleaning, use water and a sponge and rub gently
in the direction parallel with the pleats.
• If the blind gets wet, pull out the blind fully and leave to dry
naturally.
For further information or installation assistance, please con-
tact your local Distributor or our Customer Services Depart-
ment.
SKYSOL PLEATEDSHADE (Bracket Fix)
Mounting Instructions (alternative)
• The brackets can be fitted onto the flange if required. We suggest you use pan head fixings (to suit the portlight).