Operation Manual

CS250/CS240/CS231 4-59
Administrator mode
4
2
Reminder
In order to apply the changes to the settings for items which are marked with an asterisk (*), restart the
machine (turn it off, then on again).
When the machine is turned off, then on again, turn the machine off with the [Power] (auxiliary power)
key before turning off the main power switch. In addition, wait at least 10 seconds to turn the machine
on after turning it off; otherwise, the machine may not operate correctly.
IPv6 Select whether or not IPv6 is used.
If "ON" is selected, specify settings for the following.
• Auto IPv6 Setting
• Global Address
•Prefix Length
• Gateway Address
RAW Port Number Select the check box for the port to be used, and then type in the port number.
(Range: 1 to 65535)
Dynamic DNS Setting Select whether or not Dynamic DNS is enabled.
Host Name If Dynamic DNS is enabled, type in the host name (up to 63 characters).
DNS Domain Name Setting Select whether or not the DNS domain name is automatically acquired. If it is not
automatically acquired, type in the domain name below (up to 253 characters, in-
cluding the host name).
DNS Server Setting A maximum of three DNS server addresses can be registered. (Format: ***.***.***.***:
Range for ***: 0 to 255)
If the machine is set to use IPv6, an IPv6 address can also be specified.
SLP Setting Select whether or not SLP is enabled.
LPD Setting Select whether or not LPD is enabled.
Item Description