Operation Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Installing the HDD Backup Utility
- 3 Starting up the HDD Backup Utility
- 4 Registering the multifunctional product to be backed up
- 5 Backing up
- 6 Restoring
- 7 Settings
- 8 Linking to Data Administrator
- 9 Error message list
Registering the multifunctional product to be backed up
4
HDD Backup Utility 4-1
4 Registering the multifunctional product
to be backed up
Before performing a backup or restoration operation, the multifunctional
product to be backed up must be registered with the HDD Backup Utility.
If the multifunctional product is already registered, this procedure is not nec-
essary. Refer to “Backing up” on page 5-1 or “Restoring” on page 6-1, and
then perform the necessary operations.
2
Note
Multiple multifunctional products cannot be registered with the same ad-
dress.
2
Note
A maximum of 100 multifunctional products can be registered.
2
Note
If a multifunctional product is specified in Data Administrator and the
HDD Backup Utility is started up, the specified multifunctional product
can be registered in the HDD Backup Utility.
To register a multifunctional product
This procedure describes how to register a multifunctional product by spec-
ifying its IP address.
The HDD Backup Utility is an application used by administrators of multi-
functional products. The HDD Backup Utility should be used by the admin-
istrator of the multifunctional product to back up or restore the data.