Operation Manual

Using the Operator Panel
2-84 ADVANCED OPERATION GUIDE
2
Press U or V repeatedly until Others >
appears.
3
Press Z
4
Press U or V repeatedly until >Auto
Error Clear > appears.
5
Press [ENTER]. A blinking question mark
(?) appears.
6
Select On or Off using U or V.
7
Press [ENTER].
8
To exit the menu selection, press [MENU]. The display returns to Ready.
Setting the Error Clear Time
1
Press [MENU].
2
Press U or V repeatedly until Others >
appears.
3
Press Z.
4
Press U or V repeatedly until >Auto
Error Clear > appears.
5
Press Z and display >>Error Clear
Timer. The default setting is 30 seconds.
6
Press [ENTER]. A blinking cursor (_)
appears.
7
Press U or V to increase or decrease the value at the blinking cursor and
set the desired time. The time must be set between 000 and 495 seconds,
in 5-second increments. If set to 000, printing will be continued
Others >
>Auto Error >
Clear Off
>Auto Error
Clear ? Off
Others >
>Auto Error >
Clear On
>>Error Clear
Timer 030sec.
>>Error Clear
Timer 030
sec.