User's Manual

Open Platform Systems LLC © 2019
Lens Options
Three lens options are provided for fixture mounting heights from 10’ to 40’. The lenses recommended for taller
mounting heights have a narrower field of view. The narrower field of view at taller heights maintains signal strength
required for motion detection.
Wiring Connections
The controller is provided with three wires, two provide power for the controller and one is the PWM driver dimming
control:
Black – DC power (+5v to +15v, 12v nominal)
Gray – Ground
Purple – PWM dimming
FCC Regulatory Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
IC Regulatory Statements
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
1) This device may not cause interference; and
2) This device must accept any interference, including interference that may cause undesired operation of the
device.
RADIO FREQUENCY (RF) EXPOSURE INFORMATION
The radiated output power of the Wireless Device is below the Innovation, Science and Economic Development Canada
USED) radio frequency exposure limits. The Wireless Device should be used in such a manner such that the potential for
human contact during normal operation is minimized.
This device has also been evaluated and shown compliant With the ISED RF Exposure limits under mobile exposure
conditions. (antennas are greater than 20cm from a person’s body).
AVIS DU CANADA, INNOVATION, SCIENCES ET DÉVELOPPEMENT ÉCONOMIQUE CANADA (ISED)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’/nnovation, Sciences
et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, mame si le brouillage est
susceptible d’en compromettre le fonctionnement.
INFORMAFIONS CONCERNANT L’EXPOSITION AUX FRÉQUENCES RADIO (RF)
La puissance de sortie rayonnée du dispositif sans fil est inférieure aux limites d’exposition aux radiofréquences
d’lnnovation, Sciences et Développement économique Canada (ISED). Le dispositif sans fil doit étre utilisé de maniére á
minimiser le potentiel de contact humain pendant le fonctionnement normal. Cet appareil a également été évalué et montré