User's Manual

Open Platform Systems LLC © 2019
Environmental
Operating Temperature: -40C to 80C
Operating Humidity: 20-90%
IP66 compliant
Control parameters:
Motion control sensitivity – low, medium, high
Max output hold time after motion – 1 minute to 4 hours
Min output hold time – off, 1 minute to 4 hours, always on
Motion setpoint – 100 lux to 2000 lux
Max output – 30% to 100%
Min output – 0% to 90%
Daylight Control modes – Dusk to Dawn, Part Night Lighting & Motion Setpoint
Dusk Level – 5 Lux to 550 Lux
Dawn Offset Level – 5 Lux to 250 Lux
Part Night Lighting
Duration – 30 minutes to 12 hours
Offset – -4 hours to +4 hours
Time zone longitude error correction
PIR Lens
OCCSensaBLE-H – mounting height 28’ to 40’, detection range up to 50’
OCCSensaBLE-M – mounting height 15’ to 32’, detection range up to 35’
OCCSensaBLE-L – mounting height 10’ to 15’, detection range up to 25’
Weight: 98 grams
Dimensions:
Diameter: 82 mm
Height: 51 mm
ETL & CSA listed
Warranty - 5 years
Installation
1. The controller must be mounted to the bottom of the lighting fixture, with the PIR lens pointing down.
2. Choose a location in the lighting fixture that can accommodate the threaded portion of the controller and the
retaining nut.
3. Drill a 1.375” hole in the housing, install the threaded portion of the controller through the hole and tighten the
fastening nut. Make sure the rubber gasket used to seal the space between the controller housing and the bottom of
the fixture remains located in the retention groove as the nut is tightened.
4. Ensure that power is OFF, connect the black, gray and purple wires to the corresponding wires on the LED power
supply. Restore power.
5. If a different PIR lens is desired, the lens can be changed by turning one quarter turn in the CCW direction. Align
the new lens on the retention pins on the controller body and turn one quarter turn CW until the retention pin clicks
and locks into place.