Cut Sheet

F. STAINLESS STEEL FITTINGS:
Stainless steel Liquid-Tight fittings shall be made of 304-grade stainless
steel or better.
G. STAINLESS STEEL STRUTS, HANGERS, ETC.
Stainless steel strut, beam clamps, pipe straps, clamp back spacers,
conduit clamp hangers and all thread rods shall be made of 304-grade
stainless steel or better.
PART 3 – EXECUTION
3.1 EXAMINATION
A. The PVC coated ERMC and system components have been selected for
use in an atmosphere considered to be corrosive for this project. The
corrosive atmosphere is considered to be more damaging than merely the
presence of moisture. Accordingly, conduit and the corresponding fittings
for it must have PVC protection as described under Part 2 Products.
Conduit and fittings that are merely galvanized for this purpose are
insufficient.
3.2 PREPARATION
A. Preparation shall be done in accordance with manufacturer’s printed
instructions.
3.3 INSTALLATION
A. Install in accordance with manufacturer’s printed instructions and
manufacturer’s installation training.
3.4 QUALITY CONTROL
A. General: Comply with requirements of Section 01 45 13.
3.5 MANUFACTURER’S FIELD SERVICES
A. Free on-site installation training course by company representative. This
representative must conduct the onsite training course in order to qualify
for the installation certificate. The time required for this training is
estimated to be two (2) hours.
B. After the on site training installation, the representative shall then register
the installer in his database and provide certification for installation.
END OF SECTION
THOMAS & BETTS GUIDE SPECIFICATIONS 26 05 33 CONDUIT SYSTEMS FOR
CORROSIVE ENVIRONMENTS