Quick Installation Guide

6
www.observint.com
© 2018, 2020 Observint Technologies. All rights reserved.
Gimbal lock screw
Gimbal assembly
Pan range:
-30° ~ +30°
Tilt range:
0˚ ~ 75˚
Rotation range:
0˚ ~ 360˚
3. Tighten the adjustment lock screw to securely hold the gimbal in place.
4. Reinstall the camera dome cover.
5. Reinstall the camera outer cover.
Step 8. Adjust the camera image for your surveillance target
Use the rmware menus to adjust the brightness, contrast, saturation and sharpness of the video image
if necessary. These settings are initially optimized at the factory and may not need adjustment. When
adjustments are necessary, the paths to the image settings menus are dierent if the camera is installed
as a device on a LAN, or if it is connected to a NVR. Select the installation type below for your camera to
complete this step.
For cameras installed on a LAN or using a WiFi connection
1. If necessary, open IE and log into the camera with administrative credentials.
2. Click the Setup tab, and then click the Image link in the left frame.
3. Adjust the Brightness Contrast, Saturation and Sharpness of the image. Each parameter can be set to a
level of 0 ~ 100 either by moving the slider or entering the value in the box on the right. The eect of
the adjustment will appear in the Live View image in the menu.
Refer to the rmware user manual for your camera to use the other submenus on this screen.
For cameras connected directly to an NVR
1. Log into the NVR with administrative privileges.
2. Open the rmware Image menu. Go to Menu | Camera Management | Image
3. In the Camera eld drop down list, select the camera you want to congure. In the example above,
[D1]IPCamera 01 is selected.
4. Drag the Brightness, Contrast, Saturation and Hue adjustment markers left or right to perfect
the image from the camera. For some adjustments, you can click the up ( 5 )or down ( 6 )icons
near the adjustment value (on the right side) to incrementally change the value of those adjustment.
5. Click Apply to save your settings for this camera.
Refer to the rmware user manual for your NVR to use the other submenus on this screen.
Specications
Camera
Image Sensor 1 / 2.9” Progressive Scan CMOS
Min. Illumination
Color: 0.01 Lux @ (F1.2, AGC ON), 0 Lux with IR;
Color: 0.028 lux @(F2.0, AGC ON), 0 lux with IR
Shutter Speed 1/3 s ~ 1/100,000 s
Slow Shutter Yes
Day & Night IR Cut Filter
Digital Noise Reduction 3D DNR
WDR 120 dB
3-Axis Adjustment Pan: -30° ~ +30°, tilt: 0° ~ 75°, rotate: 0° ~ 360°
Lens
Focal length 2.8 mm
Aperture F2.0
FOV 2.8 mm: Horizontal eld of view: 97°, Vertical eld of view: 54°, Diagonal eld of view: 113°
Lens Mount M12