2022.1

l Output once per sheet:Option relates to Imposition (also known as N-Up) printing.
Select this box to have the OMRMark printed once per sheet rather than once per
document page.
Note
If Imposition options such as auto-positioning and scaling were selected,
these options won't apply to the Additional Content added to the physical N-
Up sheet.
l Left: Enter the distance between the left margin of the page and the OMRMark, in
either metric (cm/mm), inch (in), pixel (px) or point (pt) values.
l Bottom: Enter the distance between the bottom margin of the page and the OMR
Mark, in either metric (cm/mm), inch (in), pixel (px) or point (pt) values.
l Options Tab:
l Collation Level: Choices are:
l Document: Treats each document as a group and the group and match marks
will be set based upon the start and end of a document.
l Document Set: Treats each document set as a group and the group and
match marks will be set based upon the start and end of a document set.
l Draw Hot Spots: This adds a red rectangle around the location of each individual
mark in the output, allowing easier checking of the OMRmark logic.
l Line Options group:
l Line Thickness: Sets the thickness of each OMR mark line.
l Line Length: Sets the lenght of each OMR mark line.
l Line Spacing: Determines how the spacing between each OMR mark line will
be set. The associated control beneath the combination box will be enabled,
based upon this selection.
l Line Per Inch: If Line Spacing is set to Lines Per Inch this option will be
enabled. It defines how many lines will print per inch.
l Gap Distance: If Line Spacing is set to Gap Distance this option will be
enabled. It defines the size of the gap between lines; i.e. the distance
from the bottom of one OMR mark line to the top of the next.
Page 765