2022.1

l Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
through the wizard to return to the main selection page (the "Print options" on page700
page) and add or remove printing options from the print run.
l Print button: Click to produce print output according to the current settings. This can be
done at any point within the Wizard, whether or not all the options selected in the "Print
options" on page700 page have been completed or not.
l Cancel button:Cancels the Print Wizard, without creating any printout.
Meta Data options
This page appears as part of the Advanced Print Wizard and the "Job Creation Presets
Wizard" on page680.
The Meta Data Options page defines meta data entries that will be added to PDF output files
and optionally added to AFP output (where they are added as TLEs by default, but can be
removed in the "AFPOptions" on page705 page).
Meta data entries are ignored in all other output types, except when they are associated with
"Additional Content" on page727 or used as conditionals or in output file names, in the
Advanced Print Wizard or in "Output Creation Presets" on page987.
Note
Meta data properties have a length limitation of 255 characters.
The meta data entries can be added to any of these levels, as indicated by the tabs on top: Job,
Job Segment, Document, Document Set, and Page Tags.
Note
It is important to note that if Impositioning is used then the only meta data that will be
available to the job thereafter will be the meta data at Job Segment level.
When using Impositioning everything within the Segment is Impositioned, so all meta
data below the Job Segment level is lost.
In each of these levels, a list of entries is available in a table. The Table options are as follows:
Page 695