2022.1

l Off. Output is not reversed.
l Stack upside down:Essentially turns the stack upside down by
reversing the output imposition page sides. The last sheet becomes the
first, and in the case of duplex imposition, the back sides become the
front sides.
For presets created in a version prior to Connect 2018.2, a "Reverse
Pages" selection will apply this Stack upside down setting.
l Inverse page order:This impositions the output in the exact opposite
order from what has been selected.
For example, if the selected order was Top to bottom, left to right
(down the stack, left to right, top to bottom), then selecting Inverse page
order would result in output that was up the stack, right to left, bottom to
top.
In the case of duplex impositioning, the front and back sides don't switch.
l CropMarks group: Select to add Crop Marks to the printed output.
l Type: Use the drop-down to select whether to add Crop Marks to the page or not,
and what type of Crop Marks to use. The Crop Mark types available are Standard or
Japanese.
l Page side: What side(s) of the page to put the Crop Marks. The choices are Front,
Back or Both.
l Width: Select the width of the crop mark lines.
l Offset: How much separation (if any) to leave between the vertical and horizontal
corner markings.
l Length: Select the Length of the crop mark lines.
Advanced PrintWizard and Output Creation Preset Wizard navigation options
l Preview button (active in Advanced Print Wizard only):Click to launch a Proof Preview
window, which displays how the printed output would look based upon the currently
chosen selections.
l Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
through the wizard to return to the main selection page (the "Print options" on page700
page) and add or remove printing options from the print run.
l Print button (Advanced Print Wizard only) or Finish button (Output Creation Preset
Wizard only):
Click to produce print output/finalize the Preset according to the current settings.
Page 615