2022.1

This so the administrator can control what DLLs are loaded instead of allowing user
created configurations triggering third party DLLs at runtime.
This preferences page caters for both needs.
The PKCS#11 Modules and Tokens table contains a list of Hardware devices that can be
used by Connect.
Hardware devices can be added, modified or deleted from the table using the following buttons:
l
Add: Add a new hardware device to the list. This launches the Add PKCS#11 Module
dialog.
l
Edit: Edit that information relating to an existing hardware device. This launches the
Edit PKCS#11 Module dialog.
l
Delete: Remove an existing hardware device from the list.
The Hardware for Digital Signing preferences also provides you with buttons to :
l Restore Defaults. This option restores the preferences to Defaults. This applies to the
current Preferences page only, but not other Preferences.
l Apply: This option applies the settings made within the current Preferences page, but
does not close the Preferences dialog.
------------------------------------------------------------------------------------------
Language preferences
l Display language: Select a language from the drop-down list to be used as the language
of the User Interface (after the software is restarted).
l Default Locale: The default locale sets the locale for new templates. By default this is the
system's locale. The locale can be changed per template; see "Locale" on page332.
l Select System Locale to use the operating system's locale settings.
l Select Explicit Locale to choose a static locale from the drop-down list.
Default Locale
The Default Locale preferences are only available in the Designer Preferences. This setting
determines the locale for new templates. By default this is the system's locale. Select System
Locale to use the operating system's locale settings. Select Explicit Locale to choose a specific
Page 382