2020.2

In additional content you may use the meta data that was included during job creation (see
"Include meta data" on page956).
Note
When you combine Imposition with additional content, the content needs to be added to
every page - not once per sheet - in order to have access to the meta data on all levels. If
the option Output once per sheet is checked, only the meta data at the Job Segment
level will be available.
Inserter marks
Inserter marks can be added to the print output in accordance with the settings in an Output
Creation Preset (see "Inserter options" on page761). The available options are dependent on
the selected High Capacity Feeder (HCF) model. These machines are also commonly referred
to as Inserters or Folder-Inserters.
If no HCF file is available for a particular inserter machine, adding OMR Marks and barcodes as
Additional Content is an alternate way to drive an inserter (see "Additional content" on the
previous page).
Print using Advanced Printer Wizard
The Advanced Printer Wizard allows you to select from any and all output settings.
The Wizard can be used to generate once-off print runs (either entirely from scratch, or based
upon selected pre-existing Presets).
Note:These print runs cannot be saved as presets and can only be replicated in the following
print run, using the Last Used option.
The output settings are determined by selections made throughout the Wizard. For example, if
you want to add Inserter Marks to the output, you select the Add Inserter Marks option on the
first page of the Wizard, and the Inserter Options page will then appear later in the Wizard.
The first page of the Advanced Printer Wizard is the "Print options" on page680 page.
Page 960