2020.2

Note
If Imposition options such as auto-positioning and scaling were selected,
these options won't apply to the Additional Content added to the physical N-
Up sheet.
l
Left: Enter the distance between the left margin of the page and the Barcode, in
either metric (cm/mm), inch (in) or point (pt) values.
l
Bottom: Enter the distance between the bottom margin of the page and the
Barcode, in either metric (cm/mm), inch (in) or point (pt) values.
l
EAN-8 Properties:
l
Height: Enter the Barcode height in either metric (cm/mm), inch (in) or point (pt)
values.
l
Module Width: Specifies the width of the narrow bars. Changing this value to a
higher value will generally make the Barcode bigger. The EAN-8 barcode employs
a module width between 0.27mm and 0.66mm.
l l
Checksum: Use the drop-down to select how to deal with the Barcode
checksum:
l
Ignore: Ignore checksum calculations.
l
Auto: Add a checksum character to the Barcode if the initial value does not
validate. This is the default value.
l
Check: Verify the Barcode has a valid checksum.
l
Add: Calculate and add a checksum character to Barcode, regardless of
current value.
l
Print human readable text: Check to add a textual version of the Barcode
data.
l
Placement: Use the drop-down to select whether to place the human
readable text above or below the Barcode.
l
Font name: Use the drop-down to select the font with which to display the
human readable text.
Page 731