2020.1

l
Back and Next buttons:Used to navigate back and forth through all the selected options
within the Wizard. Up until the Print button is pressed, one can reverse all the way
through the wizard to return to the main selection page (the "Print options" on page673
page) and add or remove printing options from the print run.
l
Print button (Advanced Print Wizard only) or Finish button (Output Creation Preset
Wizard only):
Click to produce print output/finalize the Preset according to the current settings.
This can be done at any point within the Wizard, whether or not all the options selected in
the "Print options" on page673 page have been completed or not.
l
Cancel button:Cancels the Print Wizard, without creating any printout.
Imposition options
This page appears as part of the Advanced Print Wizard and the Output Creation Preset
Wizard.
Imposition refers to the printing of multiple pages on a single sheet. This is also known as N-Up
printing.
The options on the Imposition Options page allow for the setting of imposition repetition,
order, margins and markings.
As imposition selections are very specific and can be quite confusing, we have provided a
handy dynamic diagram that displays a representation of the current imposition selections in
real time. Whenever selections are changed, this display changes to reflect the selections
made.
You can even select how many pages are to be represented, whilst page numbers appear on
the pages in the diagram and change dynamically, like everything else.
It is important to note that if Impositioning is used then the only meta data that will be available
to the job thereafter will be the meta data at Job Segment level.
When using Impositioning everything within the Segment is Impositioned, so all meta data
below the Job Segment level is lost. If Booklet Binding were selected, some of the imposition
settings will be determined by the options made within the "Booklet Options" on page739 Page
and those imposition settings will thus be disabled on this page.
Page 741