2020.1

Name.
For the Coating values, the choice is about what type of coating applies (with an
"Unspecified" option as a fall back).
l
Binding Rule: This rule operates upon the binding that applies to the record.
The options are based on the Style, Side, Location or Angle of the binding. The logical
operators that apply are dependent upon the type of Binding the test is being applied to.
l
Duplex Rule: This rule operates upon the record Duplex settings. This is a binary choice
between Duplex or non-Duplex.
l
Size Rule: This rule operates upon the size of the selected group. This could be the
amount of sub-groups contained within, or the amount of physical Sheets, Pages or
Sections. The logical operators that apply are dependent upon the group that the size test
is being applied to.
l
Property Rule: This rule compares a job Property value (such as "Control Scripts" on
page412 set within Designer) against a selected string. The comparison operators that
are available for this rule are the same as those for Alphanumeric Data Rules.
Preview
This box displays a textual representation of the logical conditions set within the data filtering
table.
Finishing options
This page appears as part of the Advanced Print Wizard and the "Job Creation Presets
Wizard" on page652.
Use the Finishing Options page to force the use of specific printer finishing options, rather
than using any finishing options that might have been set in the template's Print Context and
Print Section options.
These settings are only applied when producing print output. They do not modify the original
finishing options in either the Section or the Template.
Finishing settings can be set on various levels of Job Creation, such as Document Sets and
Job Segments. This allows you, for example, to staple Document Sets whilst punching holes in
Job Segments.
You can also have multiple finishing settings at the same level.
Page 659