2020.1

Tip
It may be helpful to put scripts that have an effect on the same context or section in one
folder, because you can set the execution scope of scripts per folder (see: "Execution
scope" below).
Note
Control scripts are always executed first, regardless of where they are in the Scripts pane.
They can not be excluded from execution for a specific context or section, using the
execution scope of a folder; see "Execution scope" below. What you can do is disable the
script or the containing folder; see "Enable/disable scripts" on the facing page.
Execution scope
A particular script may be used in one context or section, but not in other contexts or sections.
Nevertheless, when processing the template, the Designer tries to find the selector of each
script in all contexts and sections – unless the script is located in a scripts folder for which the
execution scope has been set to the relevant contexts or sections. So, setting the execution
scope of a folder saves processing time.
To change the execution scope of a script:
1. Put the script in a folder; see "Script folders" on the previous page.
2.
Right-click the folder, and then click Properties.
3. Check the contexts and sections for which the scripts in this folder should run.
Note
Control scripts are always executed first, regardless of where they are in the Scripts pane.
They can not be excluded from execution for a specific context or section, using the
execution scope of a folder; see "Execution scope" above. What you can do is disable
the script or the containing folder; see "Enable/disable scripts" on the facing page.
Page 385