2018.2

l
Import: Allows importation of Rules from existing Job Creation Presets and/or
Connect Templates. You will be presented with options to either Import Finishing
Settings, or Import Media Settings, based upon what is currently selected and/or
available in the Rules table. Both options allow you to select an existing Connect
Template, from which to import the settings from, whilst Finishing settings can also be
imported from Job Creation Presets. The settings will be added to those already in the
Rules table.
l
Add: This allows you to Add various options, dynamically.
What options are available is dependant upon what rule is currently selected. For
example, the Plex group does not have an option to Add Rules available to it.
1.
Add Rule: This will add a Rule that is specific to the type of option was selected
when the Add Rule was pressed. The options are as follows:
l
Media/Trays : If the Rule is being added to a Media/Trays selection, then the
Dynamic Tray Mapping Editor Dialog will be launched. This dialog allows the
setting of all necessary
l
Finishing :If the Rule is being added to a Finishing selection, then the
Dynamic Finishing Editor Dialog will be launched.
l
Plex :Add Rule is not available as an option for Plex settings.
l
Custom : If the Add Rule is selected on a Custom Group selection, then the
Dynamic Custom Element Editor Dialog will be launched. The Custom Group
selection allows for considerable customization and complexity.
For example, they could be used to separate large documents (that might not
fit into an Inserter machine), or to use a letterhead stock that is based upon
what city the document recipient lives in.
2.
Add Custom Group: This launches the Custom Group Editor Dialog which adds a
new Custom Group entry, and associated Trigger.
3.
Add Media/Trays Group:This adds a new blank Media/Trays entry.
To add the actual Rule details you must select the new Media/Tray entry and then
select the Add Rule option.
4.
Add Finishing Group: This adds a new blank Finishing entry.
To add the actual Rule details you must select the new Finishing entry and then
select the Add Rule option.
Each selection allows you to set the appropriate details for that type of rule.
Page 685