2018.2

l
Media/Trays rules: Media/Trays settings will be pre-populated from settings contained
within the current Connect Template, if such exist. They can also be added from other
Templates, selected using the Import button. You can import settings from as many
Templates as you like.
You can also add new settings, using the Add button.
Media/Tray selections always apply to Sheets.
Once the Media/Trays are entered you will need to assign specific Printer Options (from
those contained in the PPD) to the individual Media/Tray types.
See the "Printer Options" on page687 section for how to do this.
l
Finishing rules: This allows you to set Finishing options. These settings will be pre-
populated from settings contained within the current Connect Template, if such exist.
They can also be added from Job Creation Presets and other Templates, selected using
the Import button. You can import settings from as many Templates as you like.
You can also add new settings, using the Add button.
The Finishing Rules support all industry standard binding options.
Once the Finishing Rules are entered you will need to assign specific Printer Options
(from those contained in the PPD) to each of the individual Finishing Rules.
See the "Printer Options" on page687 section for how to do this.
Note
You should also choose an Option to switch off the Finishing selection, to cater for
subset Finishing.
l
Plex rules: This fixed group allows you to set rules for sheet plexing. The choices are
Duplex, Simplex or Tumble Duplex.
You should add Printer Options for each of these Plexing Rules.
See the "Printer Options" on page687 section for how to do this.
l
Custom rules: This group does not appear by default, but can be added at any point via
the Add button.
The Rules Options. These can be selected via the icons to the right of the Rules table, or from
Page 684